1、停車場環氧地坪漆工前需確保地面干凈，如有雜物粘附需清除；

2、將環氧樹脂和固化劑按正確比例混合攪拌，并按配比加上一定的石英砂；

3、攪拌均勻后傾倒在地面上，使用鏝刀按設計的厚度將材料均勻鏝開，以增加強度和耐沖擊力；使地面更加結實，抗壓。

4、停車場環氧地坪漆施工中涂層干固后，采用打磨，把表面的流掛物、顆粒打磨平整。

5、灰塵處理干凈。

1. Make sure that the ground is clean before the parking lot epoxy floor painter, if there is any debris adhesion, it needs to be removed; 

2. Mix epoxy resin and curing agent in the right proportion and add certain quartz sand according to the proportion; 

3. Pour the material on the ground after mixing evenly, and use the trowel knife to evenly open the material according to the designed thickness, so as to increase the strength. And impact resistance; make the ground more solid and compressive. 

4. After the coatings of epoxy floor paint in parking lot are dried and solidified, the surface hangings and particles are polished and smoothed. 

5, dust disposal is clean.

檢驗方法：施工交接處理是否妥當，踢腳線位置平直，與墻壁無離間，平整。

Inspection method: Whether the construction handover treatment is appropriate, the position of kick line is straight, no separation from the wall, flat.

環氧膩?zhàn)訉?

Epoxy putty layer

1、在停車場環氧地坪漆施工潔凈后的地面上，將環氧樹脂和石英粉按正確的配比攪拌均勻后，采用批刀均勻鏝刮在地面上，以增加中涂與面層之間的結合，并進一步調整地面的平整度；

2、視實際需要施工遍數，要求達到平整無孔洞，無批刀印及砂磨印為準。

1. After mixing epoxy resin and quartz powder in the right proportion on the clean ground after parking lot floor paint construction, the batch knife is used to scrape evenly on the ground to increase the combination between the middle coating and the surface layer, and further adjust the smoothness of the ground; 

2. According to the actual needs of construction times, it is required to achieve a level without holes. No batches of knife and sand print are allowed.

檢驗方法：使地面完全平整無孔洞，無批刀印及砂磨印方可進行面涂層施工。

Inspection method: To make the ground completely flat without holes, no batch of knife prints and sanding prints before surface coating construction can be carried out.